Page 19 mrcool.com
How To Use Advanced Functions
Press CLEAN button
Airborne bacteria can grow in the moisture that condenses around heat
exchanger in the unit. With regular use, most of this moisture is evaporated
from the unit. By pressing the CLEAN button, your unit will clean itself
automatically. After cleaning has been completed, the unit will turn off
automatically. Pressing the CLEAN button mid-cycle will cancel the operation
and turn off the unit. You can use the CLEAN function as often as you like.
NOTE: You can only activate this function in COOL or DRY mode.
Clean
Press TURBO button
Turbo
When the TURBO button is pressed while the unit is in COOL mode, the
unit will blow cool air with highest fan setting to speed up the cooling process.
When the TURBO button is pressed while the unit is in HEAT mode, for
units with electric heat elements, the electric heater will activate and speed up
the heating process.
SHORTCUT function
Press SHORTCUT button(some units) to revert to previous settings:
Pressing the SHORTCUT button when the remote controller is on will cause
the system to automatically revert back to the previous settings including the
operating mode, set temperature, fan speed level, and the sleep feature
(if activated).
If the SHORTCUT button is pressed for more than 2 seconds, the system will
automatically restore the current operation settings including the operating
mode, set temperature, fan speed level and sleep feature (if activated).
Clean Function
TURBO Function
To Next Page
Loading...
Need help?
General
