MS ENERGY VORTEX - Operation

ENG

14
4.OPERATION

CHARGING

WARNING: BeforeSTARTINGTHEE‐SCOOTERFORTHEFIRSTTIME,be
suretoconnectthee‐scootertotheattachedoriginal
chargerandletitCHARGEtheBatteryfully(thelightonthe
chargerwillchangefromredtogreen)!

OTHERWISE,ITISNOTPOSSIBLETOSTARTTHEE‐SCOOTER.

IMPORTANT:
Beforeyoustartchargingthebattery,pleasecarefullyread
warningsaboutBatteriesandCargerinchapter
"IMPORTANTSAFETYINSTRUCTIONS"
Theprotectivecoverofthee‐scooterchargersocketmust
always be properly positioned in it's place to prevent water ordust
entering.Otherwise,moistureorimpuritiesmaycauseshortcircuitsor
unitmalfunction!Defectscausedbyusernegligencearenotcoveredby
thewarranty

The Charging time is influenced by temperature. Higher ambient
temperatureswillcausealongerchargingtime.
Chargethebatteryinnormalroomtemperatureenvironment!

Neverleavethescooteronthechargerunattended!


1. Openrubbercap.
2. InsertinthechargingplugFIRSTLY.
Thenplug inCharger intopower
socket!
3. While Charging process, the light
on charger will be RED. When
Battery is full, the charger led
indicatorturnGREEN.
4. After charging is completed,
disconnectChargerfromPower
socketFIRSTLY,thendisconnectchargingplugfrome‐scooter.
5. Closetherubbercap!
StandardconfigurationonIyhasasingIe
charger