MS Sedco INTERSECTOR - Page 33

MAINTENANCE
INTERSECTOR Microwave Motion and
Presence Sensor Installation Instructions
MS Sedco INTERSECTOR Installation Instructions Page 33 INTERSECTOR-1.9Uv092717
DESCRIPTION (CONT.)
Unable to detect any
vehicles during setup
process:
Random numbers are
being displayed in your
browser:
There are errors in
numbers displayed in
your setup windows:
Settings are not being
saved properly:
Vehicles occasionally
pass through zone
undetected:
Vehicles continue to be
shown after they have
departed:
SOLUTION (CONT.)
• Put unit in SIMULATION MODE to verify sensor operation.
• Adjust aim of sensor. Sensor should be pointed toward
the center of desired detection area and angled down
slightly (2-3º typical).
• Exit current Internet Explorer window and open a new
window.
• Go to Setup Menu and click on SET DEFAULT VALUES.
• Make sure to wait on web pages to load fully before
trying to save settings. Before clicking on additional
buttons, ensure that current operations are completed.
• Edit software ZONE SETTINGS. Lengthen ZONE
SETTINGS to properly match desired detection areas.
• Confirm that LEDs come on as expected when vehicles
pass through the zones. Note that if the zone is set
short, fast cars can “jump” over the zone due to the
sample rate of the sensor (20 times per second).
• Adjust aiming of sensor to ensure that it is centered and
tilted down at a slight angle.