EasyManua.ls Logo

MSA 200 LS - Safety Regulations; Correct Use

MSA 200 LS
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 Safety Regulations
1.1 Correct Use
Respiratory protective filters (gas filters, particle filters, combined filters) are used together with a face piece (full
face mask, half mask or in connection with turbo filtering devices) as filtering devices for respiratory protection if the
ambient atmosphere contains hazardous material, i.e. hazardous gases and vapours (toxic gases) as well as
particles (dusts, fumes, mists, sprays).
The half mask and the filters described in this manual are in accordance with Regulation (EU) 2016/425 and are
tested and certified by the Institut für Arbeitsschutz (IFA, Alte Heerstraße 111, 53757 Sankt Augustin, Germany,
reference number 0121) , also in accordance with Customs Union Technical Regulation for Personal Protective
Equipment TR TS 019/2011 for Russian Federation, Republic of Kazakhstan, Kyrgyz Republic, Republic of Armenia
and Republic of Belarus, in accordance with norms DSTU EN 140:2000, DSTU EN 14387:2017 and DSTU EN
143:2002 of the Ukraine.
It is imperative that this operating manual be read and observed when using the device. In particular, the safety
instructions, as well as the information for the use and operation of the apparatus, must be carefully read and
observed. Furthermore, the national regulations applicable in the user's country must be taken into account for a
safe use.
Alternative use, or use outside this specification will be considered as non-compliance.
The warranties made by MSA with respect to the product are voided if the product is not used and serviced in
accordance with the instructions in this manual. Choice and use of filtering devices are beyond the control of MSA
but are the responsibility of the user. Therefore, the liability of MSA covers only the consistent quality of this product.
The above does not alter statements regarding the warranties and conditions of sale and deliveries.
The Declaration of Conformity can be found under the following link: https://MSAsafety.com/DoC.
1.2 Safety Instructions
Oxygen Content and Toxic Material Concentration
This respiratory protective device does not supply oxygen. The permitted minimum oxygen concentration of ambient
air is governed by national regulations. They have different values for minimum levels of oxygen and this must be
taken into account for safe use (typically in the range 17% to 19.5%).
Type and concentration of the hazard in the ambient atmosphere must be known to the extent that use of a filtering
device is permissible. In case of doubt use a supplied air breathing apparatus.
Caution must be given in oxygen enriched atmospheres (ignition) or possibly explosive atmospheres (e.g. through
solvents).
The Advantage 200 half mask can be used in explosive atmospheres and is suitable for use in Gas zones 0,1 and 2
as well as in Dust zones 20, 21, 22 with all filter combinations, except for Tabtec gas filters.
Hazardous gases that are heavier than air may have a higher concentration near the ground.
Leave contaminated area in case of the following: you smell, taste or are irritated by the contaminant; breathing
becomes difficult; dizziness or distress.
Toxic Gases without Smell Recognition
Filters used for toxic gases which do not have smell recognition on the clean air side require special rules of use with
reference to the time being used and the use itself. If there is any doubt about the composition of the toxic gases, a
supplied air breathing apparatus must be used.
Before Use
When using gas filters, ensure that no particle-type toxic substances are present, and, when using particle filters,
that there are no toxic gases present. If this is not the case, combination filters must be used.
The filters must be sealed and intact.
1 Safety Regulations
6 GB

Related product manuals