ASV without warning device
GB
9
Donning the Chemical Protective Suit
For donning the chemical protection suit see operating manual for the chemical pro-
tective suit.
Connect compressed air line from the pass thru of the inside of the protective
suit to the long plug nipple.
Use of Device During Decontamination
When there is a sound of the whistle of the SCBA the external air supply may be
connected to the nipple on the outside of the suit (remove protection of the nipple).
After Use
Depending on the kind of application, the breathable air during decontamination is
supplied either by the internal SCBA or by an external compressed air feeding line.
(1) Remove chemical protective suit (see operating manual for chemical protec-
tive suit).
(2) Disconnect the compressed air feeding line from the long plug nipple of the de-
vice from the pass thru on the inside of the protective suit ( Fig. 2).
(3) Disconnect the LGDV of the facepiece (see operating manual for LGDV)
(4) Disconnect plug nipple of LGDV from lock coupling ( Fig. 1).
(5) Remove facepiece (see operating manual for full face mask).
(6) Disconnect safety coupling of the SCBA from the short plug nipple ( Fig. 1).
(7) Remove SCBA (see operating manual for SCBA)
(8) Remove the device.
FASIT Srl - Via Orsera 13/b - 34145 TRIESTE - ITALY - Tel +39 040 825604 - www.fasit.it - info@fasit.it
To Next Page
Loading...
Need help?
General
