To Next PageTo Next Page
Need help?Do you have a question about the MSA 610A and is the answer not in the manual?
General| Brand | MSA |
|---|---|
| Model | 610A |
| Category | Control Unit |
| Language | English |
General Monitors' mission to benefit society by providing safety solutions.
User responsibility for system maintenance; caution regarding static electricity and sensor poisoning.
Contact General Monitors for product info and find extensive documentation online.
Highlights wiring, auto-calibration, and front panel differences between Model 610A and 610.
Details the Model 610A as a four-channel system for monitoring combustible gases.
Details the Model 610A Controller as a four-channel system with specific channel features.
Describes the sensor assembly components and its approval for hazardous areas.
Guidelines for installing the Model 610A Controller in a weather-protected, non-hazardous area.
Details wiring for AC/DC power and emergency battery backup systems.
Describes analog output terminals and remote reset connection requirements.
Placement considerations including vapor density, air currents, emission sources, and environmental factors.
Lists materials that adversely affect sensor sensitivity and may void warranty.
Details sensor installation, approved housings, cable requirements for hazardous areas.
Overview of digital display, status indicators, mode, and reset buttons.
Initial power-up sequence, time delay, and fault indication.
Managing latched and non-latching alarms, including resetting.
Details the analog output signal range and values for different states.
Step-by-step guides for calibration check and full calibration.
Guides for viewing/changing parameters, entering passwords, and setting alarms.
Recommends calibration checks every 90 days, adjusted for conditions.
Procedure to zero out background gas concentration before calibration.
Guidelines for sensor replacement, calibration, and alarm disabling.
Describes the optional voting system for zone control using multiple controllers.
Outlines purchasable configuration options like common/discrete relays and alarms.
Recommends periodic calibration checks and maintaining a logbook.
Details annual verifications for wiring, mounting, and functional testing.
Recommendations for spare parts and returning defective controllers for repair.
Table for correcting common problems during startup and operation.
Lists fault codes displayed on the digital display and their solutions.
Contact information for General Monitors' offices in the US, Ireland, Singapore, and Middle East.
Information on where to find extensive documentation and product literature online.
Covers warranty terms and the operating principle of the catalytic bead sensor.
Provides mechanical, environmental, electrical, and system specs for the controller.
Details cable requirements and lists available GMI sensors for the system.
Details available accessories like sensor covers and lists recommended spare parts.
Provides engineering documentation including panel assembly and interconnection drawings.
Information on proper disposal of the product according to WEEE and other regulations.
