4.1.5 Installing the Suspension (when applicable)
(1) Spread the neckseal opening apart and put the suspension back into the hood.
(2) Line up the center suspension connector with the seam in the center of the hood. If
necessary, look through the lens to align the parts.
(3) Push the suspension firmly into the hood to connect the Velcro attachments.
(4) Once the center suspension connector is in position, attach each side connection
the same way. Push the suspension firmly into the hood to connect the Velcro
attachments.
4.1.6 Donning the Hood with V-Gard
®
Cap (when applicable)
NOTE: The V-Gard Cap may be used as the suspension for PAPR hoods that require a suspension. The V-Gard Cap must be
used with the OptimAir TL Hood with V-Gard Fastener Kit (P/N 10089665)
(1) Remove the standard suspension from the PAPR hood and set aside.
OptimAir TL PAPR 28
US 4 Donning and Use
To Next Page
