3-23
BIOS Setup
Integrated Peripherals
USB Controller
This setting is used to enable/disable the onboard USB controllers. Setting
options: Enabled, Disabled.
USB Legacy Support
Set to All Device if you need to use a USB device in the operating system that
does not support or have any USB driver installed, such as DOS and SCO
Unix. Set to No Mice if you want to use any USB device except the mouse.
Setting options: Disabled, No Mice, All Device.
OnBoard IDE
This setting controls the onboard IDE controller. Setting options: Disabled,
Primary, Secondary, Both.
OnBoard LAN
The field determines whether the onboard LAN controller is activated. Setting
options: Enabled, Disabled.
To Next Page
Loading...
