CX600（MS-1682）Disassemble Guide
10、 LCD MODULE ASSY
10.9：Remove the 8 screws (M2*3mm)
Attention: the screw driver torque is 1.5-2.0Kgf-cm
Component P/N Qty
Display Module S1J-A42G002-S02 1
LCD BRACKET-L E2M-6810211-A89 1
LCD BRACKET-R E2M-6810111-A89 1
Screw E43-1203003-H29 8
10.10：Remove the CMOS camera module
according to the sequence as pic shows;
Attention：don’t use too heavy strength when
removing the camera module to avoid damaging
camera module;
To Next Page
