FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates ,uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment and receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
− Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could
void the user's authority to operate the equipment. Where shielded interface cables have
been provided with the product or specified additional components or accessories elsewhere
defined to be used with the installation of the product, they must be used in order to ensure
compliance with FCC regulations.
Services web address: www.msi.com
RF Exposure Statements
The device has been evaluated to meet general RF exposure requirement. The device can
be used in portable exposure condition without restriction.
CE RED Compliance Statement
EU Simplified Declaration of Conformity
Hereby, msi Inc. declares that the radio equipment type MS-8ZBY is in compliance with
Directive 2014/53/EU. The full text of the EU Declaration of conformity is available at the
following internet address: https://www.msi.com/support
UKCA Compliance Statement
UKCA Simplified Declaration of Conformity
Hereby, msi Inc. declares that the radio equipment type MS-8ZBY is in compliance with
the essential requirements and other relevant provisions of the Radio Equipment
Regulations 2017. The full text of the UK Declaration of Conformity may be found at the
following internet address: https://www.msi.com/support
I4L-MS-8ZBY
I4L-WD04
To Next Page
Loading...
