3-13
BIOS Setup
IDE Prefetch Mode
The onboard IDE drive interfaces support IDE prefetching, for faster drive accesses.
When you install a primary and/or secondary add-in IDE interface, set this option to
[Disabled] if the interface does not support prefetching. The settings are: [Enabled],
[Disabled].
IDE DMA Transfer Access
This item is used to enable or disable the DMA transfer function of the IDE Hard Drive.
The settings are: [Enabled], [Disabled].
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/
write. If your IDE hard drive supports block mode (most new drives do), select
[Enabled] for automatic detection of the optimal number of block read/writes per
sector the drive can support. Settings: [Enabled], [Disabled].
Onboard Device
Press <Enter> to enter the sub-menu and the following screen appears:
RAID Config
Press <Enter> to enter the sub-menu and the following screen appears:
IDE RAID
This item is available for you to enable/disable the onboard IDE RAID function. Setting
options: [Enabled], [Disabled].
IDE Primary/Secndry Master/Slave RAID
This feature allows users to enable or disable the RAID function for each IDE hard
disk drive. Settings: [Enabled], [Disabled].
SATA1/SATA2/SATA3/SATA4 RAID
This feature allows users to enable or disable the RAID function for each SATA hard
disk drive. The settings are: [Enabled], [Disabled].
To Next Page
Loading...
