A-12
MS-6702 ATX Mainboard
Using 2-, 4- & 6- Channel Audio Function
6CH + S/PDIF (Optical & Coaxial)
Connecting the Speakers
When you have set the Multi-Channel Audio Function mode properly in the
software utility, connect your speakers to the correct phone jacks in accord-
ance with the setting in software utility.
2-Channel Mode for Stereo-Speaker Output
Refer to the following diagram and caption for the function of each phone
jack on the back panel when 2-Channel Mode is selected.
7
Back Panel
3
1
2
6
4
5
1 Line In
2 Line Out (Front channels)
3 MIC
4 Line Out (Rear channels, but no functioning in this mode)
5 Line Out (Center and Subwoofer channel, but no functioning in this mode)
6 SPDIF Out Optical jack
7 SPDIF Out Coaxial jack
MSI Reminds You...
This mainboard provide two different kinds of audio jacks
combination. According to the mainboard to select the proper
audio configuration below.
To Next Page
Loading...
