A-15
Using 4- or 6-Channel Audio Function
6CH + S/PDIF (Coaxial)
Connecting the Speakers
When you have set the Multi-Channel Audio Function mode properly in the
software utility, connect your speakers to the correct phone jacks in accord-
ance with the setting in software utility.
2-Channel Mode for Stereo-Speaker Output
Refer to the following diagram and caption for the function of each phone
jack on the back panel when 2-Channel Mode is selected.
* Line In function is converted
to Line Out function when 4-
Channel Mode for 4-Speaker
Output is selected.
4-Channel Mode for 4-Speaker Output
The audio jacks on the back panel always provide 2-channel analog audio
output function, however these audio jacks can be transformed to 4- or 6-
channel analog audio jacks by selecting the corresponding multi-channel
operation from No. of Speakers.
Refer to the following diagram and caption for the function of each jack on
the back panel when 4-Channel Mode is selected.
4
1 *Line Out (Rear channels)
2 Line Out (Front channels)
3 MIC
4 SPDIF Coaxial jack
Back Panel
3
1
2
Back Panel
3
1
2
1 Line In
2 Line Out (Front channels)
3 MIC
4 SPDIF Coaxial jack
4
To Next Page
Loading...
