44
M.2 Xpander-Z Gen 5 Dual card LED Control
You can turn on/ off the LEDs by the switches.
+
+
M.2 LED switch
M.2 access LED
M.2 temperature LED
FAN LED
FAN LED switch
FAN LED switch
This switch is used to turn on/ off the FAN LED.
FAN LED
• On (white) - The heatsink fan is operating correctly.
• Off - The heatsink fan is off.
M.2 LED switch
This switch is used to turn on/ off the M.2 access LEDs and M.2 temperature LEDs.
M.2 access LED
These LEDs indicate the status of M.2 SSDs.
• On (blue) - Detect the M.2 SSDs.
• Flash (purple) - The M.2 SSDs are accessing data.
• Off - No M.2 SSD detected.
M.2 temperature LED
These LEDs indicate the temperature states of M.2 SSDs.
• Red light- 65℃ and up
• Orange light- 55 ~ 64℃
• Yellow light- 45 ~ 54℃
• Green light - 35 ~ 44℃
• Blue light - 25 ~ 34℃
⚠
Important
This card can support up to PCIe 5.0 specification, but the actual speeds depend on
the M.2 SSDs, processor, and chipset being used.
To Next Page
Loading...
