MSI MEG Z490 GODLIKE

43
Overview of Components
W_FLOW1: Water Flow Meter Connector
This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.
1
1 Ground 3 WFLOW IN
2 WFLOW PWR
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
JLN1~2: Low Temperature Booting Jumper
This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
Normal
(Default)
Enabled
(Please enable this jumper
during BIOS POST.)
⚠
Important
∙ Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
∙ The overclocking results will vary according to the CPU version.
∙ Please don’t set to Enabled when power-off or the system will be un-bootable.
Enabled
(Please enable this jumper
during BIOS POST.)
Normal
(Default)
JLN1
JLN2
JSLOW1