○○○○○○○○○○○○○○○○○○○○○○○○○
2-3
Introducing Mainboard
2.2 CPU
The system supports AMD
®
Athlon
TM
, Duron
TM
, Athlon
TM
XP up to 3000+
processors in the 462-pin package. The mainboard uses a CPU socket called
Socket 462 for easy CPU installation. When you are installing the CPU, make
sure the CPU has a heat sink and a cooling fan attached on the top to prevent
overheating.
CPU Clock Frequency Selection
The hardware configuration for CPU clock frequency of the motherboard
is set to 133/166MHz by auto detect. Therefore, to make a 133MHz CPU run at
133MHz when it is installed on the board, you have to adjust the CPU clock
frequency through jumpers. To set the clock frequency for the installed CPU,
refer to Jumpers in later section.
As processor technology pushes to faster speeds and higher
performance, thermal management becomes increasingly crucial when
building computer systems. Maintaining the proper thermal environ-
ment is key to reliable operation. As such, the processor must be main-
tained in the specified thermal requirements.
AMD Athlon™/Duron™/Athlon™ XP processor with a speed of
600MHz and above requires a LARGER heatsink and fan. You also
need to add thermal grease between the CPU and heatsink to improve
heat dissipation. Then, make sure that the CPU and heatsink are se-
curely fastened and in good contact with each other. These are needed
to prevent damaging the processor and ensuring reliable operation. If
you want to get more information on the proper cooling, you can visit
AMD’s website for reference.
Thermal Issue for CPU
WARNING!
To Next Page
Loading...
Need help?
General