Hardware Setup
2-21
To Attach the Optional USB 2.0 Ports:
1. Take out the USB 2.0 bracket
2. Locate the JUSB3 and JUSB4 pin headers on the motherboard.
3. Connect the USB cables from USB 2.0 bracket to the JUSB3 and JUSB4 pin
headers separately. The blue connector of the USB bracket should be
attached to the blue pin header on the board, and the yellow connector to
the yellow pin header on the board.
4. Place the USB 2.0 bracket into the appropriate slot of the system case.
USB 2.0 Bracket
Connected to JUSB4 (yellow) & JUSB3 (blue) Separately
Note: The USB 2.0 controller is backwards compatible
with USB 1.1 spec. To use the USB 2.0 ports, you still
need to install USB 2.0 driver, which is supplied by
Microsoft for Windows
®
2000 and XP. If you have any
problems regarding USB 2.0 driver, please visit Microsoft
website for more information.
To Next Page
Loading...
