Chapter 3
3-28
When you select this function, a message as below will appear on the screen:
Type the password, up to six characters in length, and press <Enter>. The
password typed now will replace any previously set password from CMOS
memory. You will be prompted to confirm the password. Retype the password
and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.
To clear a set password, just press <Enter> when you are prompted to enter the
password. A message will show up confirming the password will be disabled.
Once the password is disabled, the system will boot and you can enter Setup
without entering any password.
When a password has been set, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any
part of your system configuration.
Additionally, when a password is enabled, you can also have AMIBIOS to
request a password each time the system is booted. This would prevent unau-
thorized use of your computer. The setting to determine when the password
prompt is required is the Password Check of the ADVANCED BIOS FEA-
TURES menu. If the Password Check is set to Always, the password is required
both at boot and at entry to Setup. If set to Setup, password prompt only
occurs when you try to enter Setup.
Set Supervisor/User Password
Note:
Supervisor password: Can enter and change the settings of the
setup menu.
User password: Can only enter but do not have the right to
change the settings of the setup menu.
(will be disabled if no supervisor password is
preset)
To Next Page
Loading...
