MSI MS-6567 - Page 70

AMI
®
BIOS Setup
3-23
OnBoard Serial Port A/B
These items specify the base I/O port addresses of the onboard Serial
Port 1 (COM A)/Serial Port 2 (COM B). Selecting Auto allows AMIBIOS
to automatically determine the correct base I/O port address. Settings:
Auto, 3F8/COM1, 2F8/COM2, 3E8/COM3, 2E8/COM4 and Disabled.
Serial Port B Mode
This item sets the operation mode for Serial Port B. Settings: Normal,
1.6uS, 3/16 Baud and ASKIR (the last three operation modes are setting
options for IR function).
IR Pin Select
Set to IRRX/IRTX when using an internal IR module connected to the IR
connector. Set to SINB/SOUTB when connecting an IR adapter to COM
2.
OnBoard Parallel Port
These items specify the base I/O port addresses of the onboard parallel
port. Selecting Auto allows AMIBIOS to automatically determine the
correct base I/O port address. Settings: Auto, Disable, 378h, 278h,
3BCh.
Parallel Port Mode
This item selects the operation mode for the onboard parallel port:
Normal, Bi-Dir, EPP or ECP.
EPP Version
The item selects the EPP version used by the parallel port if the port is
set to EPP mode. Settings: EPP1.9 and EPP1.7.
Parallel Port IRQ
When Parallel Port is set to Auto, the item shows Auto indicating
that BIOS determines the IRQ for the parallel port automatically.
Settings: 5, 7, Auto.