MSI MS-7596 (v1.x)

BIOS Setup ▍
MS-7596
3-13
BIOS Setup ▍
MS-7596
PCI IDE BusMaster
Ths tem allows you to enable/ dsable BIOS to used PCI busmasterng for readng/
wrtng to IDE drves.
OnChp SATA Controller
Ths tem allows users to enable or dsable the SATA controller.
RAID Mode
Ths tem s used to select mode for SATA connectors.
I/O Devces
Press <Enter> to enter the sub-menu and the followng screen appears:
COM Port 1
Select an address and correspondng nterrupt for the seral port.
Parallel Port
There s a bult-n parallel port on the on-board Super I/O chpset that provdes Stan
-
dard, ECP, and EPP features. It has the followng optons:
[Dsabled]
[3BC/IRQ7] Lne Prnter port 0
[278/IRQ5] Lne Prnter port 2
[378/IRQ7] Lne Prnter port 1
Parallel Port Mode
[SPP] Standard Parallel Port
[EPP] Enhanced Parallel Port
[ECP] Extended Capablty Port
[ECP + EPP] Extended Capablty Port + Enhanced Parallel Port
[B-Drectonal]
To operate the onboard parallel port as Standard Parallel Port only, choose [SPP].
To operate the onboard parallel port n the EPP mode smultaneously, choose [EPP].
By choosng [ECP], the onboard parallel port wll operate n ECP mode only. Choos-
ng [ECP + EPP] wll allow the onboard parallel port to support both the ECP and
EPP modes smultaneously.
▶
▶
▶
▶
▶
▶
▶