MS-9802 Mainboard
6-12
POST Code Checkpoints
Checkpoint  Description 
03  Disable NMI, Parity, video for EGA, and DMA controllers. Initialize BIOS, POST, 
Runtime data area. Also initialize BIOS modules on POST entry and GPNV area. 
Initialized CMOS as mentioned in the Kernel Variable "wCMOSFlags." 
04  Check CMOS diagnostic byte to determine if battery power is OK and CMOS checksum 
is OK. Verify CMOS checksum manually by reading storage area. If the CMOS 
checksum is bad, update CMOS with power-on default values and clear passwords. 
Initialize status register A. 
Initializes data variables that are based on CMOS setup questions. Initializes both the 
8259 compatible PICs in the system 
05  Initializes the interrupt controlling hardware (generally PIC) and interrupt vector table. 
06  Do R/W test to CH-2 count reg. Initialize CH-0 as system timer. Install the POSTINT1Ch 
handler. Enable IRQ-0 in PIC for system timer interrupt. Traps INT1Ch vector to 
"POSTINT1ChHandlerBlock." 
07  Fixes CPU POST interface calling pointer. 
08  Initializes the CPU. The BAT test is being done on KBC. Program the keyboard 
controller command byte is being done after Auto detection of KB/MS using AMI KB-5. 
C0  Early CPU Init Start -- Disable Cache – Init Local APIC 
C1  Set up boot strap processor Information 
C2  Set up boot strap processor for POST 
C5  Enumerate and set up application processors 
C6  Re-enable cache for boot strap processor 
C7  Early CPU Init Exit 
0A  Initializes the 8042 compatible Key Board Controller. 
0B  Detects the presence of PS/2 mouse. 
0C  Detects the presence of Keyboard in KBC port. 
0E  Testing and initialization of different Input Devices. Also, update the Kernel Variables. 
Traps the INT09h vector, so that the POST INT09h handler gets control for IRQ1. 
Uncompress all available language, BIOS logo, and Silent logo modules. 
13  Early POST initialization of chipset registers. 
20  Relocate System Management Interrupt vector for all CPU in the system. 
24  Uncompress and initialize any platform specific BIOS modules. GPNV is initialized at 
this checkpoint.