▶Chassis Intrusion
This setting enables/disables the feature of recording the chassis intrusion
status and issuing a warning message if the chassis is once opened. To clear
the warning message, set the eld to [Reset]. The setting of the eld will auto-
matically return to [Enable] later.
▶Bootup NumLock State
This setting is to set the Num Lock status when the system is powered on.
Setting to [On] will turn on the Num Lock key when the system is powered on.
Setting to [Off] will allow users to use the arrow keys on the numeric keypad.
▶Wait For ‘F1’ If Error
When this setting is set to [Enabled] and the boot sequence encounters an
error, it asks you to press F1. If disabled, the system continues to boot without
waiting for you to press any keys.
▶Network Stack
This setting enables/disables network stack.
▶Quiet Boot
This BIOS feature determines if the BIOS should hide the normal POST mes-
sages with the motherboard or system manufacturer’s full-screen logo.
When it is enabled, the BIOS will display the full-screen logo during the boot-
up sequence, hiding normal POST messages.
When it is disabled, the BIOS will display the normal POST messages, in-
stead of the full-screen logo.
Please note that enabling this BIOS feature often adds 2-3 seconds of delay
to the booting sequence. This delay ensures that the logo is displayed for a
sufcient amount of time. Therefore, it is recommended that you disable this
BIOS feature for a faster boot-up time.
▶Option ROM Messages
This item is used to determine the display mode when an optional ROM is
initialized during POST. When set to [Force BIOS], the display mode used by
AMI BIOS is used. Select [Keep Current] if you want to use the display mode
of optional ROM.
▶Boot Option Filter
This setting species a parameter used as the search lter. Only boot candi-
dates that support the preset BIOS boot mode are listed on the BIOS Setup
Utility screens in the Boot Option Priorities list.
▶Network
This setting enables/disables the network.
To Next Page
