3-9
BIOS Setup
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Settings are:
[Enabled] Shows a still image (logo) on the full screen at boot.
[Disabled] Shows the POST messages at boot.
Boot Sequence
Press <Enter> and the following sub-menu appears.
1st/2nd/3rd Boot Device
These items allow you to set the sequence of boot devices where AMIBIOS
attempts to load the operating system.
Boot From Other Device
Setting the option to [Yes] allows the system to try to boot from other device if
the system fails to boot from the 1st/2nd/3rd/4th/5th/6th boot device. Setting
options: [Yes], [No].
Hard Disk/ Removable & CD/DVD Drives
Press “Enter” and you will see the sub-menu that shows you the Hard Disk /
Removable & CD/DVD devices information. Read-only.
MSI Reminds You...
Available settings for “1st/2nd/3rd Boot Device” vary depending on
the bootable devices you have installed. For example, if you did not
install a floppy drive, the setting “Floppy” will not show up.
To Next Page
Loading...
Need help?
General
