FILTER PUMP
DOES NOT WORK
PROBLEM CAUSE SOLUTION
SPA TUB IN AN
ABNORMAL
SHAPE
Extra air pressure by strong sunlight
Check the air pressure and release some air if necessary.
During hot weather, it is recommended to
check if it is necessary to release some air to avoid any possible
damage to the spa pool
SPA LEAKING
Spa inlet/outlet connection not securely tight
Drainage valve is not closed completely
Water leaks from the spa pool body
Repair the leaking hole/spilt with the repair kit material
Tighten the inlet and outlet connection
SPA LOSES AIR
PRESSURE
Close the drainage valve. Contact the MSpa Service Center, if spa
is still leaking
WATER NOT
CLEAN
Air valve got loosen
Hole or split on the spa tub
Put soap water in a squirt bottle and spray
on seams. If there is a leak, small bubbles will come out. After you find
the leak, clean and dry the leaking area, then use the repair patch
comes with your spa to repair. Check the repair section on P15.
Inflate the spa till the Yellow section of the manometer is pushed
out. Make sure the valve is screwed tightly. Replace the valve if
necessary.
Insufficient filtering
Dirty filter cartridge
Improper water maintenance
Water has been used too long Change the water
Increase filtration frequency
Clean or replace the filter cartridge in time
Refer to the chemical manufacture's instruction
Filter stuck by dirt or other objects
Filter system failure
Clean or replace the filter cartridge
Contact local MSpa Service Center
17
NO BUBBLE
Auto-off 10 minutes
Unidirectional threshold is not open
Control panel failure
Inflation knob is in <ON> position
Wait for 10 minutes
Contact local MSpa Service Center
Contact local MSpa Service Center
Turn the knob to <OFF> position and turn on the bubble button again.
To Next Page
Loading...
Need help?
General
