22
TROUBLESHOOTING
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
PROBLEM CAUSE SOLUTION
NO DISPLAY ON THE
CONTROL PANEL
not displayed
inside are well connected
NOT HEATING
PROPERLY
water line
BUBBLE AIR BLOWER
DOES NOT WORK
OZONATOR FAILURE
inside are well connected
Contact MSpa Service Center
Contact MSpa Service Center
minimum water line
inside are well connected
section
FILTER PUMP DOES
NOT WORK
SPA LOOSES AIR
PRESSURE
WATER NOT CLEAN
secure, replace if necessary
seams. If there is a leak it will bubble. After you find
the leak, clean and dry the leaking area, then use
the repair patch comes with your spa. Check the
repair section on P20
SPA TUB IN AN
ABNORMAL SHAPE
necessary.
During hot weather, it is recommended to check if it
is necessary to release some air to avoid any
possible damage to the spa pool
SPA LEAKING
tight
Contact MSpa Service Center