mspa Tekapo - Controller Operation; Installing the Filter Cartridge; Filling the Spa with Water; Heating the Water

NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Buckle Lock Operation
Heating the water
Place the cover over the spa. Refer to
“Controller operation” to turn on the
heater.
The hourly heating rate is around 2°C -
2.5°C (2.5°F - 3.5°F) for a 2-person spa
or a 4-person square spa, 1.5°C - 2°C
(2.5°F - 3.5°F) for a 4-person round spa,
and 1.2°C - 1.8°C (2°F - 3°F) for a
6-person spa.
10
Lock Unlock
CONTROLLER OPERATION
Heater Button
LED Display
Bubble Button
Up Button
Filter Button
Timer Button
Down Button
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
NOTE: Inflate the spa tub first before installing the filter cartridge.
NOTE: Always use a filter cartridge when the spa is in use and filled with water.
WARNING: Do not overfill the spa.
Do not operate the spa until the water reaches the MIN mark.
Never move the spa tub with water inside.
Never pour water with a temperature higher than 38 °C (100°F) into the spa directly. We recommend that you fill the spa tub with lukewarm water to heat it
more quickly and save energy.
Installing the Filter Cartridge
1. Attach the filter cartridge base to the spa tub inlet grid (upper position) and turn it slightly to secure. NOTE: The filter cartridge base is designed to be
screwed on and off. Never exert force as this could cause damage.
2. Put the mesh cover on the filter cartridge then attach the filter cartridge to the base.
Filling the spa with water
1. Before filling with water ensure the bottom drain valve cap is securely closed.
2. Fill the spa tub with fresh water to a level between MIN and MAX marked on the inside of the spa wall.