4.3
4.2
4.1
1 2
3
13
SPA SET-UP
1. Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
2. Lay out all the parts on the ground and make sure all parts are accounted for. (*For missing or damaged
part, contact MSpa Service Center)
3. Spread out and connect the 9 pcs foam mat at a cleared area. Heat Preservation Mat prevents heat loss
from the bottom of the unit.
Spa wall assembly
4.1 First find the "Open-end panel" and place it to where you wish to locate your control box. Install the
"Slide Corner Beams" onto each side of the "Open-end panel".
Note: Make sure the Corner Beams with the buckle plate side should face out. The silver twist end on
the Corner Beam should be the upward side.
4.2 Continue attaching the side Corner Beams to the Wood Panels until the eight sides of the spa wall
are installed completely, and shows a octagon shape.
4.
this side
face up
4.3 Place the Sponge Rails onto the top of wood panels accordingly.
Note: The shorter side of the Sponge Rail should be face inside the spa pool.
To Next Page
