18
Celsius/Fahrenheit Toggle Button: The temperature can be displayed in either Celsius or
Fahrenheit.
Ozonator Button: Activate the Ozone. The Ozone icon should be constantly lighting when
activated. For bathers' safety concern, the ozonator cannot be operated at the same time when the
Bubbling function is on. The Ozonator will be off automatically after operating for 2 hours. The ozone
output is 30-50mg/Hr.
NOTE: Please do not soak in the spa when the Ozone is on. The Ozonator will not work when the
spa has no water or when the Bubble Button is on. The filtration cannot be turned off when Ozonator
is in use.
Filter Cartridge Cleaning Reminder: When the FILTER icon keeps flashing,
it means that the filter cartridge needs to be cleaned or replaced. After that,
press Filter button for 3 seconds to clear the reminder.
IMPORTANT: The following conditions will lead to slow water heating
● The ambient temperature is lower than 10°C (50°F)
● Outdoor wind speed is above 3.5-5.4m/s (8-12mph)
● The air bubble function is activated when heater is on
● The spa is not properly covered with the spa cover when the heater is on
Cumulative use up to 150hrs, or cleaning
reminder is activated
Check water quality in time and adjust to
recommended range
Not in used for 2~3 days or longer Use an overall cover for protection
Use water treatment products to adjust
FREQUENCY ACTION
Filter
Cartridge
SPA
Clean the filter cartridge or replace it with a
new one.The filter cartridge may need to be
replaced within 150hrs for initial use.
To Next Page
