Atom 2 SV
32
No component of your helmet can be damaged by water. Wash it with a mild detergent
in lukewarm water and let it air dry. It is recommended to wash by hand. Do not place
liner parts in the dryer: excess heat can damage the foam and liners. The shield can be
cleaned with mild soap and water. The shell of your helmet should be cleaned with water.
Do not ride without irst carefully fastening your helmet. Do not clean your helmet with
petroleum products, solvents, benzene, thinners or abrasive cleaning products. Do not
paint your helmet, otherwise your warranty will be invalidated. Do not drop your helmet
from any height onto a hard surface. This may cause damage to the inish of your helmet
and/or diminish its protective qualities. Do not place your helmet on the mirror of your
motorcycle: the strong pressure from the edge of the mirror compresses and damages
the shock absorbing liner of the helmet. Do not place your helmet on the motorcycle seat
or fuel tank. It could easily roll o and hit the ground causing irreparable damage. It is
best to place the helmet on a lat surface or, failing that, on the ground so that it cannot
roll or fall. Do not use your helmet if the shield is scratched. This can aect your vision,
especially when riding at night. Do not modify any part of your helmet, drill holes in the
shell, or cut or press on the shock absorbing liner. The installation of sound systems,
loudspeakers and microphones reduces the ability of your helmet to protect you and is
therefore not recommended. Do not reuse your helmet if it has been dropped or involved
in an accident. Replace it even if the damage is not visible to the naked eye. Do not wear
dark or tinted shields/visors in dark or poor visibility riding conditions. Do not place
interiors or pads in the dryer after washing. Allow to air dry. Do not attempt to remove,
change or replace the shield while riding your motorcycle. Fluorescent and/or glossy
inishes fade over time and with exposure to sunlight. This is normal and is not covered
by the warranty.
If you have a warranty claim, please go to
mthelmets.com/warranty
To Next Page
Loading...
