EasyManuals Logo

MTD 1P65BOB Shown User Manual

MTD 1P65BOB Shown
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7Section 3 — Set-Up
Extended Dipstick
1. Remove the oil filler cap and wipe the dipstick clean. See

Upper Limit
Oil Filler
Cap/Dipstick
Figure 3-3
2. Insert the dipstick into the oil filler neck. Turn the dipstick a
1/4 turn into the locked position to fully seat.
3. Remove dipstick. If the level is low, slowly add oil to the

4. Reinsert the dipstick into the locked position before
starting the engine.
NOTE: Do not overfill. Overfilling with oil may cause
smoking, hard starting, spark plug fouling, or oil saturation
of air cleaner.
Fuel Requirements
CAUTION: Operating the engine with E15 or E85
fuel, an oil/gasoline mixture, dirty gasoline, or
gasoline over 30 days old without fuel stabilizing
additive may result in damage to your engine’s
carburetor. Subsequent damage would not be
covered under the manufacturer’s warranty.
Use automotive gasoline (unleaded or low leaded to minimize
combustion chamber deposits) with a minimum of 87 octane.


mixture or dirty gasoline. Avoid getting dirt, dust, or water in the
fuel tank. DO NOT use E15 or E85 gasoline.
WARNING! Gasoline is extremely flammable and is
explosive under certain conditions.
 Refuel in a well-ventilated area with the engine stopped.
Do not smoke or allow flames or sparks in the area where
the engine is refueled or where gasoline is stored.
 Do not overfill the fuel tank. After refueling, make sure the
tank cap is closed properly and securely.
 
fuel vapor may ignite. If any fuel is spilled, make sure the
area is dry before starting the engine.
 Avoid repeated or prolonged contact with skin or
breathing of vapor.
Adding Fuel
WARNING! An adult should fuel this engine.
NEVER allow children to refuel the engine. Gasoline
(fuel) vapors are highly flammable and can explode.

flame many feet away from engine. To prevent injury
or death from fuel fires, follow these instructions:
NOTE: Some engines may not have the fuel cap installed for
shipping purposes. To install, remove and discard the fuel tank
dust cap labeled “Discard”. Remove the bubble wrap packaging
from around the fuel cap and tighten securely.
 DO NOT use leaded fuel.
 
from last season or stored for long periods.
 NEVER mix oil with fuel.
 DO NOT use fuel containing Methanol (Wood
Alcohol)
NOTE: 
1. Clean around fuel fill before removing cap to fuel.
2.  inch below the bottom of the

to overfill.
3. Replace the gasoline cap and tighten securely. Wipe up
spilled fuel before starting engine. If fuel is spilled DO NOT
start engine. Move machine away from area of spillage.
Avoid creating any source of ignition until fuel vapors are
gone.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MTD 1P65BOB Shown and is the answer not in the manual?

MTD 1P65BOB Shown Specifications

General IconGeneral
BrandMTD
Model1P65BOB Shown
CategoryEngine
LanguageEnglish

Related product manuals