MTP 2326 - 1 General Instructions; Preliminary

Table of Contents
TITLE
PAGE
3.2.5 Capacitance measurement
14
3.2.6 Inductance measurement
14
3.2.7 Transistor measurement
15
3.2.8 Current measurement
15
4. TECHNICAL SPECIFICATIONS
17
4.1 General specifications..
17
4.2 Measurement specifications
17
4.2.1 DC Voltage
18
4.2.2 AC Voltage
18
4.2.3 Resistance
18
4.2.4 Diode Test
19
4.2.5 Continuity Check
19
4.2.6 Transistor
19
4.2.7 Inductance
19
4.2.8 Capacitance
19
4.2.9 DC Current
20
4.2.110AC Current
20
5. MAINTENANCE
21
5.1 General maintenance
21
5.2 Battery replacement
21
1. GENERAL INSTRUCTIONS
This instrument complies with IEC 61010-1, CAT. III 1000V
and CAT.Ⅳ 600V overvoltage standards. See Specifications.
To get the best service from this instrument, read carefully
this user's manual and respect the detailed safety
precautions.
International symbols used on the Meter and in this manual
are explained in chapter 1.1.3
1.1 Precautions safety measures
1.1.1 Preliminary
* Measurement category Ⅳ meters are designed to protect
against transients from the primary supply level (overhead
or underground utilityservice).
* Measurement category III is for measurements performed
in the building installation.
NOTE: Examples are measurements on distribution boards,
circuit-breakers, wiring, including cables, bus-bars, junction
boxes, switches, socket-outlets in the fixed installation, and
equipment for industrial use and some other equipment, for
example, stationary motors with permanent connection to
the fixed installation.
* Measurement category II is for measurements performed
on circuits directly connected to the low voltage installation.
NOTE: Examples are measurements on household
appliances, portable tools and similar equipment.
* Measurement category I is for measurements performed on
circuits not directly connected to MAINS.
NOTE: Examples are measurements on circuits not
derived from MAINS, and specially protected (internal)
Ⅱ
1