4 MTS Landmark™ Tabletop Load Units - Product Information
Be aware of component movement with hydraulics off 18
Know electrical hazards 18
Ensure correct cable connection 18
Keep bystanders safely away 18
Wear proper clothing 18
Remove flammable fluids 18
Know compressed gas hazards 19
Check bolt ratings and torques 19
Practice good housekeeping 20
Protect hoses and cables 20
Provide proper hydraulic fluid filtration 20
Protect accumulators from moving objects 20
Record changes 20
Provide test area guards 20
Do not exceed the Maximum Supply Pressure 20
Do not disable safety devices 21
Use appropriately sized fuses 21
Provide adequate lighting 21
Provide adequate ventilation 21
Provide means to access out-of-reach components 21
Safety Practices While Operating the System 22
Wear appropriate personal protection 22
Provide test area enclosures 22
Specimen temperature changes 22
Handle chemicals safely 22
Know servohydraulic system interlocks 22
Know system limits 23
Do not disturb sensors 23
Ensure secure cables 23
Stay alert 23
Contain small leaks 23
Stay clear of moving equipment/avoid crush points 23
Know the causes of unexpected actuator motions 23
Do not use RF transmitters 24
Load Unit Hazard Labels 24
Hazard Labels North America (part number 100-164-553) 24
Hazard Labels Rest of World (part number 100-164-565) 25
Hazard Label for HSM Needle Valve Adjustment 26
Hazard Label for HSM Needle Valve Adjustment 27
Introduction 29
Overview 30
Contents
To Next Page
Loading...
Need help?
General
