6 MTS Landmark™ Tabletop Load Units - Product Information
Crosshead Clamping Bolt Torque Values 71
Move the Crosshead Hydraulically 71
Adjust the Grip Clamp Rate 72
Adjust the Grip Clamp Force 73
Handset Control 73
Handset Control Functions 73
Standard Test Area Enclosure Operation 75
Hydraulic Power Off 75
Specimen Installation and Setup 75
Run Mode 76
Service 76
Emergency Stop and Actuator Velocity Limiting Switch 77
Interlock logic 78
Test Area Enclosure with Light Curtain 79
Additional Station Manager and Interlock Functionality (Units equipped with elec-
tromagnetic rotary servo motor only) 81
Maintenance 83
Routine Maintenance Overview Checklist 85
Other Maintenance Tasks 90
Daily Inspections 91
Clean the Columns 91
Prevent Rust 92
Recommended Supplies 92
Maintain Airmount Pressures 95
Label Inspection 97
Adjust the Hydraulic Locks 97
Lubricate the Crosshead Locking Bolts 101
Aligning the Force Transducer 102
Required Equipment 102
Align the Force Transducer 103
Series 111 Accumulator: Maintenance Overview 106
Series 111 Accumulator: Check and Change Precharge Pressure 109
Equipment 109
Prerequisites 109
Contents
To Next Page
Loading...
