EasyManua.ls Logo

MTU 12V2000M84 - Page 4

MTU 12V2000M84
151 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8.10 Air Filter 94
8.10.1 Air filter – Replacement 94
8.10.2 Air filter – Removal and installation 95
8.11 Air Intake 96
8.11.1 Service indicator – Signal ring position check 96
8.12 Starting Equipment 97
8.12.1 Starter – Condition check 97
8.13 Lube Oil System, Lube Oil Circuit 98
8.13.1 Engine oil – Level check 98
8.13.2 Engine oil – Change 99
8.14 Oil Filtration / Cooling 100
8.14.1 Engine oil filter – Replacement 100
8.14.2 Centrifugal oil filter and filter sleeve –
Cleaning and replacement 102
8.15 Coolant Circuit, General, High-Temperature
Circuit 105
8.15.1 Draining and venting points 105
8.15.2 Engine coolant level – Check 110
8.15.3 Engine coolant – Change 111
8.15.4 Engine coolant – Draining 112
8.15.5 Engine coolant – Filling 113
8.15.6 Engine coolant sample extraction and analysis 114
8.15.7 HT coolant pump – Relief bore check 115
8.15.8 Coolant filter – Replacement 116
8.16 Raw Water Pump with Connections 117
8.16.1 Raw water pump – Relief bore check 117
8.17 Belt Drive 118
8.17.1 Drive belt – Condition check 118
8.18 Battery-Charging Generator 119
8.18.1 Battery-charging generator drive – Drive belt
replacement 119
8.19 Fuel Supply System 120
8.19.1 Water drain valve – Check 120
8.19.2 Differential pressure gauge – Check 121
8.19.3 Water level probe (3-in-1 rod electrode) –
Check 122
8.19.4 Pump capacity – Check 123
8.19.5 Coalescer filter element – Replacement 124
8.20 Wiring (General) for Engine/Gearbox/Unit 126
8.20.1 Engine cabling – Check 126
8.21 Accessories for (Electronic) Engine
Governor / Control System 127
8.21.1 Engine governor and connector – Cleaning 127
8.21.2 EMU and connectors – Cleaning 128
8.21.3 Engine governor plug connections – Check 129
8.21.4 Engine Monitoring Unit EMU 7 – Plug
connection check 130
8.21.5 Interface module EIM plug connections –
Check 131
8.21.6 Engine Control Unit – Self-test 132
8.21.7 Engine governor ECU 7 – Removal and
installation 133
8.21.8 Engine Monitoring Unit – Removal and
installation 134
8.21.9 Engine Interface Module EIM – Removal and
installation 135
8.21.10 Diagnostic features on EIM 136
9 Appendix A
9.1 Abbreviations 139
9.2 MTU Contact/Service Partners 141
10 Appendix B
10.1 Special Tools 142
10.2 Index 149
4 | Table of Contents | MS150063/03E 2016-02
DCL-ID: 0000016266 - 003

Table of Contents

Related product manuals