MTU 16V2000S56 - Page 86

4. Tighten union nut of fuel line (1) on pressure pipe neck (2) to specified tightening torque using a torque
wrench.
Name Size Type Lubricant Value/Standard
Union nut Tightening torque (Engine oil) 37 Nm +3 Nm
Fitting gasket and connecting
injector
1. Place gasket in correct position onto cylinder
head.
2. Slide terminal lugs under terminals (arrow) on injector and use torque wrench to tighten to the specified
tightening torque.
Name Size Type Lubricant Value/Standard
Nut M4 Tightening torque (Engine oil) 1.5 Nm ±0.25 Nm
Final steps
1. Install cylinder head cover (→ Page 80).
2. Open fuel supply line.
3. Vent fuel system (→ Page 89).
86 | Task Description | MS150094/02E 2015-05
TIM-ID: 0000023980 - 004