EasyManua.ls Logo

MTU 16V2000S96 - Page 68

MTU 16V2000S96
163 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
444 – SD U-PDU
Yellow alarm; warning
Cause Corrective action
Sensor of injector output stage
faulty.
u Replace Engine Control Unit.
445 – SD P-Ambient Air
Yellow alarm; warning
Cause Corrective action
Ambient air pressure sensor
faulty.
u Replace Engine Control Unit (sensor is in the ECU).
446 – SD P-HD2
Yellow alarm; warning
Cause Corrective action
Rail pressure sensor faulty, high-
pressure regulator emergency
mode;
u Check sensor B48.2 and wiring, replace as necessary
(→ Page 138).
450 – SD Idle/End-Torque Input [%]
Yellow alarm; warning
Cause Corrective action
Input signal for initial/final torque
faulty.
1. Check signal transmitter and wiring, replace as necessary.
2. Restart engine (→ Page 36).
454 – SS Power Reduction Active
Yellow alarm; warning
Cause Corrective action
Power reduction activated. u Observe any other messages.
470 – SD T-ECU
Yellow alarm; warning
Cause Corrective action
Temperature sensor for Engine
Control Unit faulty.
u Replace Engine Control Unit at next opportunity.
471 – SD HP fuel control block
Yellow alarm; warning
Cause Corrective action
Actuation of HP fuel control block
faulty.
1. Check HP fuel control block and wiring, replace as necessary
(→ Page 138).
2. Fault is rectified when engine is restarted.
68 | Troubleshooting | MS150094/02E 2015-05
TIM-ID: 0000060724 - 001

Table of Contents