Removing injector
1. Remove fuel line (1).
2. Unscrew union nut (2).
3. Pull off pressure pipe neck (3).
4. Extract fuel from the exposed bores using the
suction device.
5. Loosen terminals (arrow) on injector and pull
off terminal lugs.
6. Remove gasket.
7. Remove screw (3).
Note: Screw (3) must be used only once.
8. Take off hold-down clamp (2).
9. Carefully remove injector (1) with puller.
10. After removal, seal all openings with suitable
covers.
MS150094/02E 2015-05 | Task Description | 83
TIM-ID: 0000023980 - 004
To Next Page
Loading...
