MTU 16V2000S96 - Page 88

9. Use torque wrench to tighten thrust screw (4) to specified tightening torque.
Name Size Type Lubricant Value/Standard
Screw Tightening torque 40 Nm ±5 Nm
10. Coat mating face between union nut and HP fuel line, ball seal and thread on both ends of the new HP fuel
line (2) with engine oil.
11. Install new HP fuel line (2).
12. Observe marking on union nut (1).
13. Use torque wrench to tighten union nut (1) with marking (see arrow) to specified tightening torque.
Name Size Type Lubricant Value/Standard
Nut with marking Tightening torque 35 Nm +3 Nm
14. Use torque wrench to tighten union nut (1) without marking to specified tightening torque.
Name Size Type Lubricant Value/Standard
Nut without mark-
ing
Tightening torque 30 Nm +5 Nm
15. Observe marking on union nut (3).
16. Use torque wrench to tighten union nut (3) with marking (see arrow) to specified tightening torque.
Name Size Type Lubricant Value/Standard
Nut with marking Tightening torque 35 Nm +3 Nm
17. Use torque wrench to tighten union nut (3) without marking to specified tightening torque.
Name Size Type Lubricant Value/Standard
Nut without mark-
ing
Tightening torque 25 Nm +5 Nm
18. Install leak fuel line on cylinder head.
Final steps
1. Open fuel supply line.
2. Vent fuel system (→ Page 89).
88 | Task Description | MS150094/02E 2015-05
TIM-ID: 0000012538 - 003