EasyManua.ls Logo

MTU 18V2000G65 - Page 52

MTU 18V2000G65
155 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fault
code no. Full designation Meaning Action
Setting parame-
ter no.
229 AL Stop Camshaft Sen-
sor Defect
Engine stop due to camshaft
sensor fault (and a previous
crankshaft sensor fault in the
same operating cycle). Alarm
configuration parameter, see
PR 2.8008.100 for explana-
tion.
Check connector
and wiring to sensor
B1, replace as nec-
essary. Fault is rec-
tified when engine is
restarted. If cam-
shaft and crankshaft
sensor are both faul-
ty, check connector
and wiring to sensor
B1 and B13. Re-
start. Fault is recti-
fied when engine is
restarted, contact
Service if this is not
the case.
1.8004.562
230 SD Crankshaft Speed SD alarm configuration,
crankshaft sensor faulty,
short circuit or wiring dam-
age, engine remains opera-
tional.
Check sensor and
wiring (B13), at-
tempt restart, fault
may be rectified
when engine is re-
started. Contact
Service if this is not
the case
1.8004.498
231 SD Camshaft Speed SD alarm configuration, cam-
shaft sensor faulty, short cir-
cuit or wiring damage, engine
remains operational.
Check sensor and
wiring (B1), attempt
restart, fault may be
rectified when en-
gine is restarted.
Contact Service if
this is not the case.
1.8004.499
240 SD P-Fuel SD alarm configuration, en-
gine remains operational,
fuel pressure sensor faulty,
short circuit or wiring dam-
age.
Check sensor and
wiring (B34), replace
as necessary.
1.8004.565
245 SD ECU Power Supply
Voltage
SD alarm configuration, inter-
nal engine governor fault.
Execute engine gov-
ernor self-test, re-
place engine gover-
nor in case of fault.
2.8006.589
266 SD Speed Demand SD alarm configuration, ana-
log speed setting faulty,
short circuit or wiring dam-
age.
Check speed setting
transmitter and wir-
ing, replace as nec-
essary. Fault is rec-
tified when engine is
restarted.
2.8006.586
269 SD Loadp.Analog filt. SD alarm configuration, fil-
tered analog signal of load
pulse not available, short cir-
cuit or wiring damage
Check wiring, re-
place as necessary.
Fault is rectified
when engine is re-
started.
2.8006.588
52 | Troubleshooting | MS15018/03E 2016-02
TIM-ID: 0000008508 - 003

Table of Contents

Related product manuals