Functions:
• Starter control (start repetition, tooth alignment, starter protection)
• Generator monitoring
• Open bus interface to the plant (SAE J1939)
• Emergency stop function with line break monitoring
• Redundant power supply
• Optional control of emergency-air shutoff flaps
• Key switch logic
• Interface to ECU and EMU
• MCS5 dialog interface
• Control of an MTU lube-oil priming pump (power components in separate MTU PPC Box)
• Connection facility for an MTU Local Operating Station (LOS)
Serial RS422 interface for diagnosis
The engine interface is divided into two parts. The first part is integrated in the engine wiring harness via the
62-pole Tyco connector X52. The second part is formed by those signals involving a higher current. Such
signals are routed out via M threaded pins and are also integrated in the engine wiring harness.
Functions
• ECU supply
• EMU supply
• Plant signals (ECU7 connector X1)
• Bus interface (2x MCS5 CAN)
• CAN dialog output (1x MCS5 CAN)
• ECU and EMU emergency stop
• Electric starter
• Terminal 45 starter A/B (engaged)
• Pneumatic starter
• Starting air pressure valve
• Starting air pressure sensor
• Barring device (Barring Gear 1 and 2)
• Generator (with exciter control)
• Optional emergency-air shutoff flaps
• Activation of SDAF 1+2
• Feedback from SDAF 1+2
Electronic engine control unit (ECU)
Closed-loop control:
• Engine speed
• High-pressure fuel
Valve gear:
• Injection (fuel pressure, injection timing, injection duration, operating status)
• Sequential turbocharging (cutting-in and out) with secondary turbocharger
• Engine protection with multi-stage safety systems:
– Power reduction
– Power limitation
– Emergency stop
22 | General Information |
MS150060/04E 2016-02
TIM-ID: 0000002177 - 005
To Next Page
Loading...
