MTU 8V2000Mx4x - 8.5.2 Cylinder head cover - Removal and installation

8.5.2 Cylinder head cover – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Torque wrench, 8-40 Nm
F30043446 1
Centering device
F6783025 1
Gasket
(→ Spare Parts Catalog)
Preparatory steps
1. Remove air filter (→ Page 100).
2. Remove air guide housing.
Removing and installing cylin-
der head cover
1. Remove screws (1).
2. Remove cylinder head cover (2) with gasket
from cylinder head.
3. Clean installation surface.
4. Check condition of gasket of cylinder head
cover.
Result: Replace damaged seals.
5. Align cylinder head cover (2) with centering
device.
6. Insert and tighten screws (1).
Final steps
1. Install air filter (→ Page 100).
2. Install air guide housing.
3. Check cylinder head covers for leaks.
MS150060/04E 2016-02 | Valve Drive | 83
TIM-ID: 0000004470 - 003