Installing injector
1. Prior to installation, remove all blanking
plugs.
2. Fit new O-rings on injector and coat with as-
sembly compound.
3. Secure new sealing ring with assembly com-
pound on injector, observing installation posi-
tion of sealing ring.
4. Clean sealing surface on cylinder head and
protective sleeve.
5. Insert injector (1) in cylinder head, ensuring
that it is correctly aligned with the HP line
connection.
6. Fit hold-down clamp (3) in correct installation
position, coat screw (2) with engine oil.
7. Screw in screw (2) and tighten by hand.
8. Coat thread and sealing cone of HP line (5)
and injector (1) with engine oil.
9. Align injector (1) and HP line (5) with align-
ment device.
10. Connect HP line (5) to HP accumulator and
tighten by hand.
11. Connect HP line (5) to injector (1) and tighten
by hand.
12. Tighten screw of hold-down clamp (3) with a box wrench adapter and a torque wrench to specified tightening
torque.
Name Size Type Lubricant Value/Standard
Screw M10 x 85 Tightening torque (Engine oil) 40 Nm + 4 Nm
13. Use socket wrench and torque wrench to tighten HP line (5) to the specified torque.
Name Size Type Lubricant Value/Standard
HP line Tightening torque (Engine oil) 30 Nm + 5 Nm
14. Attach cable (4).
Final steps
1. Install cylinder head cover (→ Page 83).
2. Open fuel supply to engine.
86 | Injector | MS150060/04E 2016-02
TIM-ID: 0000004650 - 005
To Next Page
Loading...
