Mueller DH-5 - DH-5 Drilling Machine General Information

MUELLER
®
DH-5 / EH-5 Drilling Machines
General Information
2
Feed Tube & Yoke
Collar
Ratchet Handle
Oil Hole
Clean-Out Notch
Bleeder Valve
Capacity and Use
The DH-5 Drilling Machine is a hand
or power operated machine used for
drilling holes
1
/8” to 2
1
/8” inclusive,
in any size or kind of pipe (Under
certain conditions the maximum size
may be increased to 3
3
/4”.)
For complete information on the
uses of this machine and the tools
and equipment required for its use
see the latest Mueller Gas Catalog
at muellergas.com.
Working Pressure and
Temperature Rating

Working Pressure

The working pressure or
temperature rating is reduced
accordingly if any attachment, valve,

or temperature during the drilling
operation has a maximum working
pressure or temperature rating

Equipment Furnished







The machine adapter, cutter
arbor, shell cutter and pilot drill
shown at right are not included in
the equipment furnished with this
machine. These items must be
ordered according to the size and
type required.
Length of Travel
DH-5 Drilling Machine has

NOTE: For Operating Instructions
see pages 4 and 5. For DH-5
Drilling Machine Parts see page 6.
Machine Weight Chart
DESCRIPTION DH-5
Machine & equipment

shipped in wooden
(48.5 kg)
storage chest

67 lb
 
Cutting Grease
Double Open-end Wrench
Adjustable Wrench
Body Gasket
DH-5 Drilling MacHine
Machine Adapter Nipple
Cutter Arbor
Shell Cutter
Pilot Drill
Locking Mechanism
Body Gasket