TROUBLESHOOTING YOUR SINGLE SERVER BREWER
Beyond these recommended cleaning and maintenance procedures this Brewer
guide.
PROBLEM CAUSE SOLUTION
Brewing a partial cup
1) K-Cup® pack Holder may
be clogged
2) Water is not enough to
brew the selected size.
3) Calcium or scale is built up
in the brewer.
1) Clean K-Cup® pack Holder if
necessary and rinse under faucet
2) Make sure there is
enough water in the reservoir to
brew the selected serving size
3) De-scale the Brewer
1) The reservior is not empty
before removal.
Water in reservoir base
1) Remove the water reservoir,
Turn off the brewer with the
on/offbutton, press the on/off
button and keep it pressed for 3
seconds, the pump starts to drain
the water of the base.
2) Use a dry sponge to absorb the
water if any.
1) Ground coffee sticked on to
the Water Outlet gasket as a
result the sealing is not good.
Coffee drops around the
brewer hold when brewing
Pull off the gasket gently and
rinse the gasket with water, put it
back gently after rinse.
Temperature sensor does not
work properly.
The on/off button is flashing
Call service line.
1) The brewing is stopped
manually.
2) The handle or brewer head
is lift while the button is
flashing
Water spitting from the outlet
of the brewer head.
1) Leave the brewer to escape
steam/residual water
completely, in 20 seconds from
the brewing process is
interrupted.
It is normal, depending on
K-cup from different brand.
lift while the button is flashing
K-cup is shrinked after
brewing
Check to be sure that it is
plugged in securely.
Brewer does not have power
Plug into a different outlet.
No water in the reservoir.
The handle is lift.
Check to make sure there is
water in the reservoir
Close the handle, the 3
serving buttons will flash if the
handle is lift.
Brewer cannot brew
13
To Next Page
Loading...
