70
71
The support modes have the following characteristics:
Eco
Lowest pedal assistance. Particularly suitable for journeys on level, good road
surfaces without any particular inclines and with low load. On long distances,
the highest range is achieved in Eco mode.
Normal
Medium pedal assistance. Suitable for journeys on routes with alternating flat
and slightly uphill sections and changing surfaces and for journeys with me-
dium load.
High
Strongest pedal assistance, suitable for trips on challenging routes with many
inclines and with heavy load.
In addition, you can also ride the e-muli px very well with the assistance swit-
ched o, for example, to save battery capacity on long distances. The switched-
o drive does not produce any increased pedaling resistance.
Do not change the support levels while riding, but stop briefly to select another
support mode.
For more information on assistance levels, refer to the enclosed Pendix system
manual. Please also take care when setting the
Please also take care when setting the support levels not to change them while
riding.
Charging the battery
You can charge the battery both on the supplied plate station and without the
plate station directly on the cable. To charge the battery directly on the cable,
lay the battery on its side and insert the plug into the contact point of the bat-
tery.
The plug ts only in certain position and locks magnetically. An illumination of
the LED indicator tells you that the charging process has been initiated. When
fully discharged, an average charging process takes about three hours.
You can charge the battery at any time and do not have to wait until it is com-
pletely discharged. The life of the battery is not shortened by this charging. The
so-called „memory eect“ does not occur.
Check the battery at regular intervals to ensure that it is
intact. Do not open or disassemble your rechargeable bat-
tery. Danger of explosion!
Charge the battery at an ambient temperature of 15 to 25
degrees Celsius. In winter and cold weather, allow the bat-
tery to warm up to room temperature before charging it. If,
on the other hand, the battery has warmed up during ope-
ration, allow it to cool down rst.
Battery and control unit
Pendix eDrive 300
To Next Page
Loading...