EasyManua.ls Logo

muli ST+PX - Page 37

Default Icon
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
72
73
Only charge the battery with the original charger. Ne-
ver use the charger of another manufacturer; even
if the plug of the charger should t to your battery.
Using the wrong charger can cause the battery to heat
up, ignite or even explode!
Charge your battery in good time and make sure that
you do not deep discharge the battery. The rechar-
geable batteries do not know any memory eect and
can be charged without problems at any charge level.
Before performing any work on your e-muli such as
maintenance, repair, assembly or transporting it,
switch o the drive system and remove the battery.
There is  risk of injury if the drive system is activated
unintentionally.
It is best to charge the battery during the day in 
dry room equipped with  smoke or re detector. Be
sure to place the battery on  non-flammable surface
when charging.
If you do not use your e-muli for  longer period of time (e.g.
in winter), remove the battery and store it in  dry room at
temperatures between 5 and 20 degrees Celsius. The bat-
tery should be charged to at least 50%. Check the charge
level every 2 months and recharge the battery if necessary.
Never use  defective battery or charger.
Make sure that the battery and charger do not get into the
hands of children!
Never expose the battery to re or high heat. Danger of ex-
plosion!
Do not expose the battery or charger to direct sunlight
when charging.
Battery and control unit
Pendix eDrive 300