8
MultiModemISDN User Guide
Features
The MTA128ST-USB communicates over public ISDN telephone lines. Features include:
• Compatibility with EuroISDN (ETSI/DSS1/NET3), French VN4, and Japanese INS64 switch
protocols
• USB interface for easy installation; hot-swappable (Windows 2000 and Windows 98) with other
USB devices without restarting or reconfiguring your PC
• Compatibility with U.S. NI-1, AT&T 5ESS, and DMS-100 switch protocols
• Compatibility with V.110*, V.120, ML-PPP, and X.75 protocols
• ISDN BRI (2B+D) and analog ports
• USB port (Type B)
• Support of PPP (Point-to-Point Protocol) for high speed ISDN connections
• Tone detection to allow use of a standard telephone for ISDN line access (an ISDN telephone
is not required)
• Automatic detection of incoming calls as voice or data
• Windows 2000 and Windows 98/95 software utility for easy ISDN line configuration
• AT commands, S-registers, and result codes
• Ability to use the same communications software as analog modems
• Flash memory for easy firmware upgrades
* The MTA128ST-USB is manufactured in two builds. To determine the build of your terminal
adapter (TA), issue the ATI2 command in a terminal window. If the TA responds to the command
with MTA128ST-USB, then it supports V.110. If your TA resonds to the ATI2 command with
MTA128ST-USB-RC, V.110 support is not available.
To Next Page
Loading...