98
MultiVOIP 200 User Guide
S0=1 Answer after 1 ring
S2=43 Set escape character to + (ASCII 43)
S3=13 Set carriage return character to CR (ASCII 13)
S4=10 Set line feed character to LF (ASCII 10)
S5=8 Set backspace character to BS (ASCII 8)
S7=45 Wait 45 seconds for connection before aborting
S10=20 Set DCD drop time to 700 ms
S25=5 Set DTR detect time to 500 ms
S32=20 Set escape sequence guard time to 2 seconds
S34=2 Set maximum escape sequence character length
S50=1 Caller Line ID enabled
S52=1 Auto-Protocol Detection enabled
S53=2048 Maximum X.75 buffer size is 2048 characters
&S1 DSR follows DCD
V1 Select verbose messages
!Z=x The data protocol is not modified
Profile 1 (&F1
)
— V.110 Asynchronous Operation*
* The MTA128ST-USB is manufactured in two builds. To determine the build of your terminal
adapter (TA), issue the ATI2 command in a terminal window. If the TA responds to the command
with MTA128ST-USB, then it supports V.110. If your TA resonds to the ATI2 command with
MTA128ST-USB-RC, V.110 support is not available.
AT COMMAND DESCRIPTION
&C1 DCD functions normally
$D0 Disable persistent DTR dialing
&D1 Hang up when DTR drops
E1 Enable command mode echo
&E4 Enable hardware flow control
&E6 Discard XON/XOFF characters
&E13 Enable pacing
#X0 Disable Sending Multiple Xoff Characters
&J0 Disable Automatic Channel Bundling
%E1 Enable +++ escape method
%E4 No OK response to +++ or <break> escape
&R1 CTS always high
S0=1 Answer after 1 ring
S2=43 Set escape character to + (ASCII 43)
S3=13 Set carriage return character to CR (ASCII 13)
S4=10 Set line feed character to LF (ASCII 10)
S5=8 Set backspace character to BS (ASCII 8)
S7=45 Wait 45 seconds for connection before aborting
S10=20 Set DCD drop time to 700 ms
S25=5 Set DTR detect time to 500 ms
S32=20 Set escape sequence guard time to 2 seconds
S34=2 Set maximum escape sequence character length
S50=1 Caller Line ID enabled
S52=1 Auto-Protocol Detection enabled
To Next Page
Loading...