User Manual
Step 3: Connect to multimeterBLE software
(1) After installing the Bluetooth USB adapter driver successfully, run the multimeterBLE
software, the configure dialog box appears.
Make sure that the Bluetooth USB adapter is plugged into the computer.
To find the “Port” (COM #), you will need to look for it under "Ports (COM & LPT)" in
Device Manager window.
Select the port number, and click "OK".
(2) Turn on the multimeter, press and hold until appear on the display.
(3) Click softkey on the right, a Scan Devices dialog box appears. A progress bar
shows the progress of scanning multimeters. It will take a few seconds. When the
To Next Page
Loading...
Need help?
General
