MULTISPAN PID 2303-1C User Manual

HIGH ALARM:
INBAND ALARM
ABSOLUTE LOW ALARM
ABSOLUTE OUTBAND ALARM
RLY-OFF
RLY-OFF
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-OFF
RLY-OFF
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-OFF
RLY-ON
RLY-OFF
RLY-OFF
RLY-OFF
RLY-OFF
RLY-OFF
RLY-OFF
S.V
High Set Point
High Set Point
High Set Point
SET
HYST
Low Set Point
Low Set Point
Low Set Point
HYST
Specifications are subject to change, since development is a continuous process,
So for more updated operating information and Support,
Please contact our Helpline: 9081078681/9081078683 or
Email at Ver:2103service@multispanindia.com
ALARM OPERATION
R3-Alarms
1) Heater Break alarm: - If the current of the Heater < AMP SV
(unhealthy condition) then Relay turns ON and Upper
Display will show , middle display will blink showing . hbr h
To manually turn off Relay, press ENT key 4 sec. Display will
continue showing till the fault is rectified.hbr
2) Cold start (CS) alarm: Relay is initially OFF. When PV >
Alarm SV, Relay turns ON. When PV < Alarm SV MINUS
HYS, Relay turns OFF.

MULTISPAN PID 2303-1C Specifications

General

Brand	MULTISPAN
Model	PID 2303-1C
Category	Controller
Language	English